Tightening Up - Truper SINCO-10X2 Manual De Instrucciones

Tighten up the rotating table to make miter cuts
• To make 45° and up to -45° miter cuts use the rotating
table (16).
• Loosen the miter knob lock (20) and press the quick
adjustment lever (16) to release the rotating table.
• Turn the table into the desired angle. Use the miter scale
(19) as an aid. This scale is built with 0°, ±15°, ±22.5 °
±31,6° and ±45° stops to quickly set the most common
miter angles.
• Release the lever to fix the table.
WARNING • Double-check the knob is tightened to
fix the table before starting to cut. Otherwise the table
could move and cause a severe injury.
Tighten up the cutter head to make bevel cuts
• To make up to 45° bevel cuts adjust the cutter head
column into the desired angle.
• Loosen the bevel cut knob (28).
• Move the column using the bevel cut scale (29) as a
guide.
• Once the column is in the desired angle tighten the knob
to block its position.
WARNING
• Double-check to tighten the knob to
fix the column before starting to cut. Otherwise the cutter
head could move and cause severe injury.
• To return the cutter head to 0° position loosen the bevel
cut knob and return the column to 0° position until the
blocking lock for 0° bevel cuts gets automatically inserted
and securing the column in that position. Tighten the bevel
cut knob.
45°
bevel cut
10
ENGLISH
0°
bevel cut
28

Tightening Up

20
16
18
19
0° miter cut
29
45° miter cut
20
-45° miter cut