Cutting Disc Replacement - Truper SINCO-10X2 Manual De Instrucciones

Assembly

Cutting disc replacement

CAUTION
• Wear protective gloves to prevent
injuries when changing or setting the cutting disc.
• Disconnect the tool from the power source.
• Lift and push backwards the cutter head.
• Remove the screw (a).
• Lower the retractable guard to uncover the screw
securing the cutting disc (B).
• Press the shaft lock (C) while rotating manually the disc
until it gets locked.
• Using the included wrench remove the screw securing
the disc altogether with the washers (D).
• Remove the cutting disc.
• Apply a drop of lubricant in the inside and outside
A
Tightening Up
Telescopic cutter head
• The cutter head is built with two rails (32) running in the
cutter head column to move away or approach the support
regarding the job to be done.
• Loosen the rails blocking lock (33) to move the cutter
head.
• Once is set into the desired position, fasten the rails
blocking lock to fix the cutter head into that position or to
leave it unblocked to make long cuts.
32
33
washers onto the side where they make contact with the
cutting disc.
• Set the new cutting disc into the shaft assuring the inside
washer is sitting correctly on the disc.
• Reverse the former steps to fasten the disc, return the
inside plate, the retractable guard and the retractable arm
into their original position before using the tool.
• Double-check the guard is operating normally before
starting the tool.
• Turn on the saw for a little while to verify the disc is
correctly assembled.
B
C
9
ENGLISH