Working With The Device - Rothenberger ROCAM 4 Instrucciones De Uso

 Position camera head (1) with cable (3) into the reel (4).
 Bayonet connection operated by a half turn, and pulling gently (hold counterpart).
 Use caution not to damage the connector!
 Loosen locking bolts by pulling gently from the lock and Turning it 90 °. Restrain reel (4) to
prevent from slipping.
 Push reel (4) toward T-slot and remove the side. Use caution not to damage the connector.
 Mount in reverse order, paying attention when inserting the reel (4) on mark.
The software automatically detects the connected camera head.
3.4

Working with the device

Wear protective clothing! Always stand next to the reel cable!
 Push reel cable (3) with bending spring (2) from the holder / reel (4) take and remove cap.
 Remove the cap from the camera head (1) and screw on the bending spring (2).
Caution: Check for cleanliness and damage!
 If necessary, additional accessories can be attached to camera. When using pipe diameters
greater than 50 mm, always use guide body!
 Clean the pipe system before inspection.
 Press button on the bottom cover, open the cover. Hold the door during opening.
 Turn the device on with the Power-button, located bottom front center of the monitor. The
monitor unit can be removed from the basic device for optimal viewing angle.
Excessive pressure on the touch screen may damage the monitor unit!
 Remove the camera head (1) from the holder and pull the cable (3) from the reel (4). The
cable is rigid and is under mechanical stress. Therefore, hold it firmly when unwinding from
the reel. By pressing in the holder / bracket, it can be clamped!
 Guide the camera head (1) into the pipe system and carefully push it with the cable (3). Cau-
tion: Unwinding the reel too quickly may cause it to continue to spin.
Do not pull the cable (3) over sharp edges, and do not bend it!! Check the camera
cable before each use for damage!
While it is being pushed, the cable (3) may loop: Breakage may result!!
During advancement through several pipe bends, the camera image is always upright.
 After work is finished, pull the cable (3) out of the pipe and push it directly onto the reel (4).
Remove coarse dirt and water with a rag while winding cable on reel.
 Clean thoroughly (see section 4.).
 Dismantle accessories and insert bending spring (2) with rell cable (3) into the reel (4).
 Camera head (1) and accessories should be cleaned and safely stored.
 Close the flap.
Camera head and accessories must be cleaned after each use and stored safely.
Abnormal transport of the camera head can cause damage!
ENGLISH 13