Battery Removal/Installation - Hitachi CG 14DSDL Instrucciones De Manejo

English
1 Battery (BSL1830) ................................1
2 Charger (UC18YGSL) ...........................1
3 Nylon head ............................................1
CG18DSDL
4 Cover ....................................................1
(LSC)
5 Hex. bar wrench 4 mm ..........................1
6 17×19 Combi box wrench .....................1
7 Protective glass ....................................1
1 Battery (BSL1830) ................................2
2 Charger (UC18YGSL) ...........................1
3 Nylon head ............................................1
4 Cover ....................................................1
CG18DSDL
(2LSC)
5 Hex. bar wrench 4 mm ..........................1
6 17×19 Combi box wrench .....................1
7 Protective glass ....................................1
8 Battery cover ........................................1
1 Battery (BSL1830) ................................1
2 Charger (UC18YRSL) ...........................1
3 Nylon head ............................................1
CG18DSDL
4 Cover ....................................................1
(LSR)
5 Hex. bar wrench 4 mm ..........................1
6 17×19 Combi box wrench .....................1
7 Protective glass ....................................1
1 Battery (BSL1830) ................................2
2 Charger (UC18YRSL) ...........................1
3 Nylon head ............................................1
4 Cover ....................................................1
CG18DSDL
(2LSR)
5 Hex. bar wrench 4 mm ..........................1
6 17×19 Combi box wrench .....................1
7 Protective glass ....................................1
8 Battery cover ........................................1
Standard accessories are subject to change without notice.
14
OPTIONAL ACCESSORIES (sold separately)
1. Battery
(BSL1430)
2. Battery cover
Optional accessories are subject to change without notice.
APPLICATIONS
Trimming, scaling and mowing of weed.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the housing tightly and push the battery latches to
remove the battery (see Fig. 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see Fig.
2).
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to a receptacle.
When connecting the plug of the charger to
a receptacle, the pilot lamp will blink in red
(At 1-second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in
Fig. 3 and 4 (UC18YGSL), Fig. 5 and 6 (UC18YRSL).
3. Charging
When inserting a battery in the charger, the pilot lamp
will light up continuously in red.
When the battery becomes fully recharged, the
pilot lamp will blink in red (At 1-second intervals).
(See Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
(BSL1830)