Periodic Maintenance And Cleaning; Overview Of Maintenance Schedule; Visual Inspection Of Mechanical + Electrical Safety Technology; Gears - Kerbl HAPPYCOW MiniSwing Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 68

5. Periodic maintenance and cleaning

The machine must only be operated in a fault-free condition! You must shut down the machine immediately if you
discover any damage or malfunction!
Caution!
Risk of physical injury to people and animals and material damage!
• only perform maintenance and cleaning work when the machine is switched off. Disconnect the mains plug!
• maintenance and cleaning work must only be carried out by trained personnel
• illegible or damaged stickers (e.g. type plate) must be replaced immediately with new ones.

5.1. Overview of maintenance schedule:

Component
Visual inspection of mechanical +
electrical safety technology

Gears

Screw connections

Moving parts (pendulum bearings, brush
bearings)
Brushes
Entire machine

5.2. Visual inspection of mechanical + electrical safety technology:

• daily inspection of the machine for externally visible damage and general functionality.
• check of the status of the electrical cables and the control box (bite marks, wear spots, loose connections, etc.).
Repair work on electrical components must only be carried out by a qualified electrician taking account of electrical
safety regulations.
• disconnect the power, e.g. via the fuse
• secure against power reconnection
• check voltage-free state
• earthing and short-circuits
• cover and separate neighbouring parts that are carrying voltage
5.3. Gears
The gap between the brushes and the gears and the seals in each case must be checked weekly for soiling (hair!) and
cleaned where necessary. If cleaning is not carried out promptly, hair can be pulled / pressed into the seals, causing loss
of oil, bearing damage and possibly even damage to the gears. The oil level must also be checked on a weekly basis.
The gears have already been filled at the factory with Shell Omala S4 WE gear oil. Top up any lost oil using only this type
of oil.
5.4. Screw connections
Check all screw connections weekly to ensure they are tight, especially the securing of the machine to the wall. Tighten
any screw connections where necessary.

5.5. Moving parts

Lubricate the bearings and bushings at the locations marked (fig. 7). These parts must be inspected regularly and chan-
ged if they are wearing too much. When changing transmission parts, always use a hoist (front loader, pulley) to guard
against falling or sagging!! Risk of injury!
Cleaning
Lubrication
x
X
x
34
Inspection
x
x
x
x
x
x
Frequency
Daily
Weekly
Quarterly

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

18890

Tabla de contenido