Periodic Maintenance And Cleaning - Kerbl HappyCow Swing Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 59
There are 2 LEDs on the control card
Designation
DL1
DL1
DL2

5. Periodic maintenance and cleaning

The machine must only be operated in a fault-free condition! You must shut down the machine immediately if you
discover any damage or malfunction!
Caution!
Risk of physical injury to people and animals and material damage!
• only perform maintenance and cleaning work when the machine is switched off. Disconnect the mains plug!!
• maintenance and cleaning work must only be carried out by trained personnel
• illegible or damaged stickers (e.g. type plate) must be replaced immediately with new ones.
5.1. Overview of maintenance schedule:
Component
Visual inspection of mechanical +
electrical safety technology
Gears
Screw connections
Moving parts (pendulum bearings, brush
bearings)
Brushes
Entire machine
5.2. Visual inspection of mechanical + electrical safety technology:
• daily inspection of the machine for externally visible damage and general functionality.
• check of the status of the electrical cables and the control box (bite marks, wear spots, loose connections, etc.).
Repair work on electrical components must only be carried out by a qualified electrician taking account of electrical
safety regulations.
• disconnect the power, e.g. via the fuse • secure against power reconnection • check voltage-free state • earthing and
short-circuits • cover and separate neighbouring parts that are carrying voltage
5.3. Gears
The gap between the brushes and the gears and the seals in each case must be checked weekly for soiling (hair!) and
cleaned where necessary. If cleaning is not carried out promptly, hair can be pulled / pressed into the seals, causing loss
of oil, bearing damage and possibly even damage to the gears.
The oil level must also be checked on a weekly basis. The gears have already been filled at the factory with Shell Tivela
S320 gear oil. Top up any lost oil using only this type of oil.
Colour
Description
red
Tilt sensor (white/brown/green connection cable - dip switch 1 OFF)
LED OFF: Tilt sensor in the rest position (brush not moving)
LED ON: Tilt sensor activated (brush rotating)
red
Tilt sensor (grey/brown/black connection cable - dip switch 1 ON)
LED ON: Tilt sensor in the rest position (brush not moving)
LED OFF: Tilt sensor activated (brush rotating)
red
Power available
Cleaning
Lubrication
x
x
X
x
36
Inspection
Frequency
x
x
x
x
x
Quarterly
Daily
Weekly

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

18880

Tabla de contenido