Technical Data - EINHELL TH-HA 2000/1 Manual De Instrucciones Original

Anleitung_TH_HA_2000_1_SPK8__ 06.11.2017 10:19 Seite 18
GB
the same point for a long time.
Do not use in explosive atmospheres.
n
Warmth may be carried to inflammable materials
n
which are concealed.
After use, let the appliance cool on the stand
n
before it is put away.
Do not leave the appliance unsupervised when it
n
is in operation.
2. Layout and items supplied (Fig. 1/2)
1. Nozzle
2. 3-setting ON/OFF switch
3. Power cable
4. Heat nozzle
5. Wide nozzle
6. Reducer nozzle
7. Reflector nozzle
8. Paint scraper
Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Original operating instructions
n
3. Proper use
The hot air blower is designed for heating shrink-fit
hoses, for removing paint and for welding and
shaping plastics.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
18
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

See warranty card of your country.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
6. Starting up
Important!
After you use the equipment for the first time, some
smoke may escape from it. This is normal.
6.1 3-setting ON/OFF switch (Figure 3)
Select the required working temperature and air
volume with the ON/OFF switch (2).
Within a very short space of time the hot air gun
will reach operating temperature.
Switch position 1:
1. Setting – 350°C / 300 liters/min.
Center position:
Equipment is switched off.
Switch position 2:
2. Setting – 550°C / 500 liters/min.
6.2 Possible uses for the hot air pistol:
Removal of paint and lacquer.
n
Attention! Hazardous or poisonous gasses
may be produced while removing paint or
lacquer. Be sure to provide adequate
ventilation.
Removal of stickers and decorations.
n
Loosening of rusted or tightly fastened nuts and
n
metal screws.
Thawing of frozen pipes, door locks, etc.
n
Attention: no not attempt to thaw plastic or
synthetic pipes.
Accentuation of natural wood grains before
n
staining or lacqueing.
Shrinkage of PVC packaging foils and insulation
n
tubes.