Start-Up - hafele FT 200 Manual De Instrucciones

5. Start-up

The system is supplied in simple operation mode for stand-alone operation (SA). This
document describes the start-up process for stand-alone operation only.
Start-up details for using the system with Dialock software applications can be found in the
Dialock software documentation.
The start-up process begins automatically once the power plug has been connected.
The individual steps must be carried out immediately and in sequence.
For safety reasons, the initial start-up can only take place within 5 seconds of plugging
in the power plug.
• Read through the steps carefully before start-up.
• Have both master keys ("green" programming key and "red" clearing key) at the
ready before start-up commences.
• Perform the work operations quickly and without interruptions.
If the start-up time window is exceeded:
1. Pull the power plug.
2. Wait until the LED goes out.
3. Restart the start-up process.
Alternatively, start-up can also take place by pressing the Reset button

( 9. Extensions and connections, page 65).
1. Press and hold down the reset button only until the first, short acoustic signal.
ATTENTION! If the button is pressed for longer, a reset will take place

( 12. Reset, page 70).
51