Troubleshooting; Care And Maintenance; Care; Maintenance And Repair - Rothenberger R 80 Instrucciones De Uso

 Remove the guide hose (3) from the machine.
 Retract the spiral segments from the tube and remove from the machine.
 Deposit the spiral in the spiral basket. Clean tools and spirals prior to this.
5

Troubleshooting

Symptom
Machine does not run
Screw does not advance when the
feed handle has been operated.
6

Care and Maintenance

Caution: Disconnect mains power supply before carrying out any maintenance!
6.1

Care

The equipment should be handled with care and cleaned regularly.
After every use the screws and tools should be cleaned and treated. We recommend our special
cleaning agent „ROWONAL"(see 7. Accessories). The machine has a lubricating point at the
drive shaft in the area of the clamping jaws, which has to be lubricated using an universal
grease after ten hours operation in each case. In general, all mobile parts in the area for
stressing the clamping jaws are to be lubricated regularly.
6.2

Maintenance and Repair

Important! All maintenance and repair work should only be carried out by
experienced service personnel.
6.3 Replacing the clamping jaws
 Dismantle the front cover
 Release the two cylinder screws on the front cap
 Remove the front cap
 Remove the individual clamping jaws and replace by new ones
 Install in the reverse order
7

Accessories

Accessory Name
Spiral Basket Ø 22 mm x 22.5
Spiral Basket Ø 22, 32 mm x 18
Spiral Guide Hose
Clutch Jaws Ø 22 mm
Clutch Jaws Ø 32 mm
Separating Pin Ø 22, 32 mm
Telescoping Guide Tube Ø 22, 32 mm / 1.9 – 4.3 m
Spiral Retrieving Device
14
Possible Reason
No power supply
Main switch faulty
Motor faulty
PRCD switch
Clamping jaws worn
Drive belt worn
ROTHENBERGER Part Number
No. 72112
No. 72111
No. 72559
No. 72561
No. 72562
No. 72101
No. 72131
No. 72135
ENGLISH
Solution
Check mains power supply
Call Customer Service
Call Customer Service
Press the RESET button on
the PRCD switch
Replace clamping jaws
Replace drive belt
(B-4)