Timer Function - Taurus MY BREAD Manual De Instrucciones

- Press the browning selector button to
select the desired browning level (light, dark)
- Press the weight selector button to select
the weight of bread desired (450g / 680g /
900g).
- Switch the appliance ON pressing the
ON/OFF button for 3 seconds. A short beep
is heard and the two dots in the time display
being to flash as the program starts. In order to
stop a program, press the ON/OFF button for 3
seconds until a beep confirms that the program
has been switched off.
- The remaining cooking time will appear on the
visualization screen.
- Select the appliance function desired.
- Select the desired power.
- Select the desired speed.
- Select the desired cooking temperature.
- In order to minimize the generation of acryla-
mide during the toasting process, avoid reach-
ing dark brown colours on the toasted bread.
- After the selected time the appliance will switch
off automatically.
- The appliance can be switched on again using
the switch once the control device has cooled,
if it is not switched on again, do not force it,
allow it to cool.

TIMER FUNCTION:

- The appliance's operating time can be con-
trolled.
- To program the operating time simply select it
using the buttons.
- Time + Time –
- The time programmed or remaining time will
appear on the display (E).
- Use the adjustments buttons to advance the
time. If necessary, use them to decrease the
time. When the delay timer is set where you
want, make sure to press the ON/OFF button
to confirm the program selected for the time
selected. The two dots in the time will flash and
your bread will be ready when you planned.
- The time which appears on the clock after it
switches on automatically is the remaining
baking time. Therefore, ensure you set the time
for when you would like the bread ready.
- If you work with the delay timer function, do not
use any easily perishable ingredients such as
eggs, fresh milk, etc...
- To return to normal operation simply press
lightly on the weighing platform and wait for the
screen to show 2:50.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off switch
for 3 seconds.
- Unplug the appliance from the mains.
- Remove the bowl pilling on the handle an-
ti-clockwise, using a cloth as it will be hot.
- Remove the bread from the bowl with the help
of a wooden spatula or similar heat resistant
implement; do not use utensils that could dam-
age the non-stick coating.
- Allow to cool for 20-40 minutes before cutting
- Put the cable back in the cable housing.
- The cable housing means you can remove and
have available the required length of cable for
working with the appliance, preventing accident
risk situations.
- Close the lid.
- Clean the appliance.
- Cable compartment
- This appliance has a cable compartment situat-
ed on its underside.
- Carry handle/s:
- This appliance has a handle on the bottom
part of the body, which facilitates comfortable
transportation.
ACCESSORIES:
MEASURING CUP ACCESSORY (H)
- This accessory is used for measuring quanti-
ties.
MEASURING SPOON ACCESSORY (I)
- This accessory is used for measuring quanti-
ties. One side is for soup spoon measure, the
other side for tea or coffee spoon measure.
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.