Adjustment Mode - LaserLiner Cubus Manual De Instrucciones

Adjustment mode

Take the alignment of the rotary laser into account when performing
adjustment work.
X axis adjustment
Activate adjustment mode: Switch on the Cubus. Simultaneously
press the ON/OFF button and the auto/slope button until the
LED auto/slope flashes rapidly.
Adjustment: Use the positioning buttons to move the laser from its
current position to the height of reference point A2. Keep pressing
the positioning buttons at second intervals until the required position
is reached.
Cancel adjustment: Switch the device off.
Save: Pressing the scan button saves the new adjustment settings
Adjust the Y and Z axes
Activate adjustment mode: Switch on the Cubus. Simultaneously
press the ON/OFF button and the auto/slope button until the
LED auto/slope flashes rapidly.
Switch to the Y axis using the tilt button. (LED auto/slope)
Adjustment: Use the positioning buttons to move the laser from its
current position to the height of reference point A2. Keep pressing
the positioning buttons at second intervals until the required position
is reached.
Cancel adjustment: Switch the device off.
Save: Pressing the scan button saves the new adjustment settings
To adjust the Z axis, set up the device vertically
and proceed in the same manner as for the
X axis adjustment.
Regularly check the adjustment before
!
use, after transport and after extended
periods of storage. Always make sure
to control all axes.
Cubus / Cubus G
X- / Y- /
Z
Z-Axis
Y
X
23
EN