Installing The Stove; Assembly Sequence - Olsberg Tenorio PowerSystem Compact Manual De Instrucciones

Installing the stove

and horizontal. The stove may only be installed on an
non-combustible spark protection plate must be used.
This must extend 50 cm to the front and 30 cm to each

Assembly sequence

side beyond the edge of the combustion chamber
opening. Under the stove no spark protection plate is
● The Ø 150 stovepipe connection can be installed at
the top or rear. The stove is supplied ready for con-
nection from above. If you wish to connect it at the
rear, the following steps must be carried out to make
- Break out the cover in the back panel.
- Replace the connector sleeve and the sealing
cover.
● Install storage stones.
Comply with the information in the instruction manu-
al included with the storage stones.
● Decide where the stove is to be installed. There
The floor on which the stove is installed must be even
must be no objects made of combustible materials
within a distance of 80 cm of the stove's radiation
adequate load­bearing floor. The stove can be stood
area, measured from the combustion chamber's in-
on a metal floor sheet or glass sheet to protect the
spection glass, nor may any be placed within this
flooring.
If the flooring or carpet is inflammable, a stable and
Depending on the installation position of the stove in
or load-bearing), the following distances from walls
need to be observed in accordance with the position
of the combustion chamber door to the wall / side
required.
panel or the back panel (see schematic diagram).
When not dealing with walls that need to be protect-
ed, you merely need to observe a minimum distance
of approx. 5 cm to allow for proper heat dissipation.
● Install the pipe lining (provided on site) in the chim-
ney. The connection height can be individually spec-
not exceed 1.5 m from the connector sleeve. For the
the necessary modifications:
rear stovepipe connection heights please refer the
"Technical Data" chapter. No combustible material is
permitted within a radius of 20 cm around the stove
pipe.
● Connect the stovepipe at both connection points
with stove putty so that the stove pipe is permanent-
ly sealed.
● Push the stove onto its planned position and orient it
The stovepipe connections must be tight. The
stovepipe must not protrude into the chimney.
Bear in mind that on partition walls in accordance
area subsequently.
of 85°C can be reached, and with light wallpaper
front of walls that need to be protected (flammable
or similar combustible construction materials this
can result in colour changes.
14
ified for a top stovepipe connection, however should
so that the stovepipe fits into the pipe lining.
with test specification EN 13240 the temperature
27 cm
Stove installed straight in corner
14 cm
Stove installed diagonally in corner
27 cm