Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.2.3. Connection of inlet and outlet
Connect the inlet and outlet lines once the pit has been filled as far as the connections.
3.2.4. Positioning of the assembly components
After connecting the inlet and outlet lines, check whether the assembly components are
in a vertical position. If they are not, position them according to the following figure. Push
the inlet pipe towards the wall of the tank until the spacer touches the wall. The outlet
pipe must be pushed as far in the direction of the wall, until the complete pipe cross
section is still visible from above on the installed structure.
Positioning the pipe axis
3. Assembly and Installation
Position the inlet and outlet constructions vertically
KLsepa.pop
25
Publicidad
Tabla de contenido
