Graf KLsepa.pop NS 1 SAPHIR Instrucciones De Montaje página 28

3.2.6. Installation of adaptors and the telescopic dome shaft
The profile gasket ⑥ must be mounted
onto the tank opening and the adaptor ⑤
inserted as far as the stop. Before
inserting the adaptor, the seal must be
lubricated with soft soap.
The seal ④ is mounted into the adaptor
and the telescopic dome shaft ③ is
inserted
3.2.7. Installation of telescopic dome shaft directly onto the tank
In order to install the telescopic dome shaft onto
the tank, the profile gasket ⑥ is mounted onto
the tank opening and the telescopic dome shaft
is inserted.
3.3. Installation of the shaft structures
Instructions regarding the covers: The covers used for grease separators must meet
the provisions of DIN EN 124 and must be marked with the inscription "Separator". The
cover(s) must not be equipped with openings to vent and should be fastened with screws
due to odour formation.
3.3.1. Accessible
In order to prevent transferring loads onto the
tank, the telescope is filled with layers of
grounded gravels (maximum grain size 8/16)
and compacted evenly. Subsequently an
Ottocoll M500 cord is inserted into the groove
of the telescopic dome shaft ③, then insert
the hose seal ②. On top of the hose seal a
cord of Ottocoll M500 also needs to be
applied. Finally, the concrete cover ① is
placed onto the telescopic dome shaft.
3. Assembly and Installation
KLsepa.pop
3
4
6
6
1
3
5
2
27