Parts Description; Functional Description - Makita HNU01 Manual De Instrucciones

PARTS DESCRIPTION

1 Battery cartridge
2 Indicator lamp
3 Control grip
4 Switch trigger
014182

FUNCTIONAL DESCRIPTION

WARNING:
Always be sure that the tool is switched off and
•
the battery cartridge is removed before adjusting
or checking functions on the tool. Failure to switch
off and remove the battery cartridge may result in
serious personal injury from accidental start-up.
Installing or removing battery cartridge
CAUTION:
Always switch off the tool before installing or
•
removing of the battery cartridge.
Hold the tool and the battery cartridge firmly
•
when installing or removing battery cartridge.
Failure to hold the tool and the battery cartridge
firmly may cause them to slip off your hands and
result in damage to the tool and battery cartridge
7
8
9
10
11
5 Hanger (suspnesion point)
6 Loop handle
7 Front grip
8 Shaft
012942
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
6
1
2
3
6
4
5
9 Angle lock
10 Gear case
11 Blades
and a personal injury.
2
1
1. Red indicator
2. Button
3. Battery
cartridge
3