Rack Mounting - Samson Concert 88x Manual De Propietario

Rack Mounting

The CR88x receiver can be installed into a standard 19" rack for transport or permanent
installation using the included rack ears. Follow the simple steps below to mount the CR88x:
Attach the included rack ears by sliding each rack ear into
the groove on either side of the CR88x until they lock into
place, and the receiver flush with the front panel.
Position the CR88x receiver into an
available rack space and slide in until the
rack ears are touching the rails of the rack
case and are aligned with the rack rail
holes.
Mount the receiver into the rack using
the appropriate size rack screws (not
included). To ensure equal tension and
balance when installing the receiver,
you should secure screws in a crisscross
pattern of opposite corners: top left ->
bottom right -> top right -> bottom left.
In order to mount two CR88x receivers in one rack space, the system includes a center
connection piece. Slide the center connection piece into the groove of each receiver and attach
the short rack ears to each receiver. Mount the receivers into the rack using the crisscross
pattern described above.
Concert 88x Wireless System 15