Bosch BSG8 Serie Instrucciones De Uso página 7

Ocultar thumbs Ver también para BSG8 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
de
Vacuuming
You have bought an extremely powerful
device. The highest suction setting is
therefore only recommended for heavily
soiled, short-pile carpets and hard
floors.
7
Figure
The required suction power can be select-
ed by adjusting the suction regulator.
Low
suction range:
For vacuuming delicate fabrics, e.g.
curtains.
Moderate
suction range:
For daily vacuuming of lightly soiled
floors.
High
suction range:
For vacuuming durable floor cover-
ings, hard floors and for heavily soiled
surfaces.
Turbo range:
For vacuuming stubborn dirt and very
heavily soiled surfaces.
8
Figure
Adjusting the floor tool:
For vacuuming rugs
and carpets
For vacuuming
hard floors
Caution!
Floor tools are subject to a certain
amount of wear, depending on the
type of hard floors you have (e.g.
rough, rustic tiles).
Therefore, you must check the
underside of the floor tool at regular
intervals. Worn undersides of floor
tools may have sharp edges that can
damage sensitive hard floors, such as
parquet or linoleum. The
manufacturer does not accept any
responsibility for damage caused by
worn floor tools.
Vacuuming with accessories
Figure
Remove the combination tool
upwards out of the accessory holder.
a)Crevice nozzle
b)Upholstery nozzle
c)Hard furnishings brush
=>
=>
10
For vacuuming in crevices and
corners.
For difficult-to-reach places, the
combination tool can be extended
in two stages by pulling out the
crevice nozzle like a telescope.
Pull out the crevice nozzle in two
stages until it audibly clicks into
place.
The crevice nozzle can be pushed
back together by releasing the
telescopic locks (press in the
direction of the arrow).
For cleaning upholstered furniture,
curtains, etc.
For window frames, cabinets,
profiles, etc.
Fold up the upholstery nozzle in the
direction of the arrow.
The brush ring is extended by
turning in the direction of the
arrow.
The brush ring must be turned
back in and the upholstery nozzle
folded back up before the
combination tool is inserted into
the accessory holder.
en
5

Publicidad

Tabla de contenido
loading

Tabla de contenido