Notes Regarding Special Types Of Hazard - Kemper SmartFil Instrucciones De Servicio

Setting up, maintenance and repair work and troubleshooting must only be performed
when the product is switched off.
Always tighten bolt connections that have been loosened during repair work. If specified,
tighten the relevant bolts with a torque wrench.
In particular, protect connections and screw connections from dirt or care products at the
beginning of maintenance/repair/care
The time frames for periodic testing/inspections stipulated or specified in the operating
instructions must be observed.
Before disassembling, mark the parts that belong together.

2.6 Notes regarding special types of hazard

WARNING
Skin contact with cutting fumes, etc. can cause skin irritation in susceptible individuals.
Repair and maintenance work on the product may only be carried out by trained and
authorised personnel while complying with the safety rules and the applicable accident
prevention regulations.
Serious injury to the lungs and respiratory tract is possible!
In order to avoid contact with and inhalation of dust, use protective clothing, gloves and
a blower respirator system.
The release of hazardous dusts during repair and maintenance is to be avoided to ensure
that persons not charged with the task are not affected.
DANGER
Any work on the electrical equipment of the product must only be performed by a
qualified electrician or by trained personnel under the direction and supervision of a
qualified electrician in accordance with electronic regulations.
Before opening the product, pull the plug, if available, and secure it against accidental
switch-on.
For faults with the product's electrical energy supply, immediately switch the product off
at the on/off switch and if available, also pull the plug.
Use only original fuses with the prescribed amperage.
Electrical components, on which inspection, maintenance and repair work must be
carried out, must be disconnected from the power supply. Secure equipment that has
been used for disconnection against unintentional or automatic reconnection. Firstly
check that no voltage is present in activated, electrical components, then isolate
adjacent components under voltage. When making repairs, ensure that constructive
characteristics are not altered in a way that reduces safety.
Check cables regularly for damage and replace if necessary.
1502818-00 - 41 -
EN