Notes Regarding Special Types Of Hazard - Kemper MiniFil Instrucciones De Uso

KEMPER MiniFil Operating manual - EN

2.6 Notes regarding special types of hazard

Electrical Systems
Work on the electrical equipment of the filter device may only be carried out by a
trained electrician or by trained personnel under the guidance and supervision of a
skilled electrician in accordance with electrotechnical regulations!
Before opening the device, disconnect the power supply and secure it against
unintentional reconnection.
In the case of disturbances in the electrical energy supply of the filter device,
immediately switch off the filter device by pushing the on/off/auto switch and remove
the power plug.
Use only original fuses with the prescribed amperage!
Electrical components, on which inspection, maintenance and repair work must be
carried out, must be disconnected from the power supply. Secure resources which
have been activated against unintentional or automatic reconnection. Firstly check
that no voltage is present in activated, electrical components, then isolate adjacent
components under voltage. When making repairs, ensure that constructive
characteristics are not altered in a way that reduces safety.
Check cables regularly for damage and replace if necessary.
Noise
The A-assessed equivalent sound pressure level of the filter unit is
LpA ≤ 74 dB(A) at 50% extraction power.
A higher sound pressure level at the location of the filter unit may result due to other
machines and/or by the local circumstances. In this case, the operator is obliged to
provide the operating personnel with the appropriate protective equipment.
- 43 -
Technical modifications and errors expected.