Kemper MaxiFil Instrucciones De Servicio página 58

Item Name
1 Device button with power light
2 Signal light
3 Built in regulator for run-on time in start-stop operation
4 Maintenance socket (for service staff only)
5 Pressure measurement opening (only for service
employees)
6 Signal horn
7 Connector socket for start-stop sensor
8 Pressure switch (for service staff only)
• I / 0 switch (Pos. 1)
The product is switched on and off by pressing the switch.
The green control lamp in the switch control panel shows that the product is
operating without malfunctions or shows operational readiness if an optional
start-stop sensor is fitted.
• Indicator lamp (Pos. 2)
If the yellow indicator lamp is illuminated the following faults may have occurred:
These faults are displayed using different blink codes for optical reference.
• Indicator lamp blinks evenly at regular intervals:
– Device maintenance is due, inform service
.• Indicator lamp blinks briefly twice in a row at regular intervals:
– The motor protection relay has triggered, inform service
.• Indicator lamp blinks briefly three times in a row at regular intervals:
– Incorrect rotating field, the fan is rotating in the wrong direction. To
rectify this, an electrician must exchange two phases in the CEE plug
• Built in regulator for run-on time in start-stop operation (Pos. 3)
If a start-stop sensor (optional) has been fitted, the extraction system run-on time
can be adjusted to between 5 and 60 seconds after completion of welding
operations.
1502762-00
Tab. 12: Operating controls
- 57 -
EN
Information