Maintenance; Care - Kemper MaxiFil Instrucciones De Servicio

7 Maintenance

The instructions in this chapter are intended as minimum requirements. Depending
on the operating conditions, further instructions may be required to keep the product
in optimal condition.
The maintenance and repair work described in this chapter must only be performed
by specially trained repair personnel of the operating company.
Spare parts used must comply with the manufacturer's specified technical
requirements.
This is guaranteed if original spare parts are used.
Ensure that supplies and replaced parts are disposed of properly and in an
environmentally friendly manner!
Please observe safety notes listed in these operating instructions for any maintenance
work.

7.1 Care

Care of the product is limited in general to cleaning all surfaces from dust and
deposits as well as checking the filter inserts.
The warning notices listed in the chapter "safety notes for maintenance and fault
removal on the product" must be observed.
INFORMATION
The product may not be cleaned with compressed air! This may result in dust
and/or dirt particles getting into the ambient air.
Proper care helps to maintain the product in a continuous functional state.
• The product must be cleaned once a month.
• The exterior areas of the product can be cleaned with a suitable industrial vacuum
cleaner of dust class H or alternatively wiped with a wet cloth.
7.2 Maintenance
Regular inspection and servicing have a positive effect on the reliable functioning of
the product and should be carried out at least once a year.
The device operates maintenance-free except for the necessary filter replacements.
Observe the warning notices for servicing and troubleshooting in the "Safety"
chapter.
1502762-00 - 61 -
EN