Chapter 8 - Operation And Use - Corghi ERCO Serie Manual De Uso

CHAPTER 8 - OPERATION AND USE

8.1 Controls
LIFT WITHOUT MECHANICAL SAFETY DEVICES
The controls for using the lift are:
Main switch (10)
The main switch has two positions:
Position 0: the electrical circuit of the lift is not powered; it is possible to secure the
switch using a metal padlock to prevent its use. Position 1: the electrical circuit of the
lift is powered.
UP button (5)
If pressed, it activates the motor and the lift will go up.
DOWN button (6)
If pressed, it activates the down solenoid valve and the lift will go down.
End of travel button (7)
If pressed before safety height detection (400 mm), it activates the acoustic warning
signal.
If pressed after safety height detection, it activates the acoustic warning signal and,
after a few seconds, the down solenoid valve for the final travel.
NOTE: Press the end of travel button (7) to lower the lift fully.
Internal acoustic
warning signal/buzzer
Warning light (9)
117