Lavorwash WINDY foam Instrucciones De Montaje página 13

FOAM SUCTION
Preparation: (see fig.⑥)
- Fix the flexible hose L into the suction inlet H.
- Fix, at the end of the flexible hose L, the most sui-
table accessory.
- Insert brass nozzle Z (foam injection).
Operation:
- Plug the unit in.
- Start the suction and choose 1 or 2 motors by the
switch B (see fig. ②).
For new foam injection:
- Turn on the switch B, to detergent position
fig.②).
- Press lever D for foam outflow.
INJECTION-EXTRACTION WASHING
SYSTEM BY LIQUID DETERGENT
- Disconnect the unit to air compressor unit (not
supplied) to coupling V1.
- Remove brass nozzle Z.
- Insert plastic nozzle Z1.
- Press lever D for liquid detergent outflow.
DRY SUCTION
Preparation:
- Insert the filter E and E2 and fix it by screw (see
fig.⑦).
- Or insert other filter (Optional, not supplied) (see
fig.④⑤) .
- Start the suction and choose 1 or 2 motors by the
switch B (see fig. ②).
Pneumatic filter shaker C : If there should be a reduc-
tion in the suction power, operate quickly the filter re-
set lever C several times to reset the filter (see fig. ⑨).
WET SUCTION
Preparation
(see fig.⑥)
- Remove the filter E1, E2.
- Start the suction choose 1 or 2 motors by the
switch B.
END WORK
- When you've finished, turn off the switch B.
. (see
- Use the lever D on the tap to drain the residual
detergent.
CARE AND MAINTENANCE
The unit is maintenance-free.
The machine shall be disconnected from its power
source, by removing the plug from the socket-
outlet, during cleaning or maintenance
- Clean the exterior part of the machine with a dry
cloth.
- Move the appliance only by catching the carrying
handle located on the motor head.
- Store the appliance and the accessories in a dry safe
place, out of the reach of children.
FILTER CLEANING E
(see fig. ⑪)
1- Remove the filter
2- wash tge filter
3- Let the filter drying befor reassemble it
Once the filter has been cleaned, check whether it
is suitable for further use. If it has been damaged or
broken, replace it with an original filter.
- The paper filter cannot be reused once full or
clogged. Replace with original spare parts.
- If the device is used for particularly fine pow-
ders (smaller than 0,3 µm), special filters sup-
plied optionally (Hepa) must be employed.
13