Lavorwash WINDY foam Instrucciones De Montaje página 12

repair.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similary
qualified persons in order to avoid a hazard.
Should extension cables be used, ensure that these
lay on dry surfaces and protected against water jets.
Before vacuuming liquids, check the float functions
correctly. When vacuuming liquids, and when the
tank is full, a float closes the suction opening, and the
vacuum operation is interrupted. Then switch off the
machine, disconnect the plug and empty the tank.
Regularly clean the water level limiting device (float)
and examine it for signs of damage.
If the machine overturns, it would be recommended
to release the trigger gun and then stud up the
machine.
If foam or liquid escape from the appliance, switch off
immediately.
The equipment should not be used to pick up
water from containers lavatories, tubs, etc.
Aggressive solvents or detergents should not be
used.
Service and repairs must be carried out by qualified
personnel only. Only use manufacturer original spare
parts for service repair.
The manufacturer cannot be held responsible for
any damage/injury caused to persons, animals or
property caused by misuse of the appliance, not in
compliance with manual instructions.
42 The machine must be always used on horizon-
tal bases.
43 Keep the machine on plane surfaces.
44 Do not use the machine without proper filters.
32Foam function: connect the device to a 4 bar
minimum air compressor (not supplied).
33Foam function: Using specific detergents is in-
dispensable for foam production.
34Always test on a hidden area of the material.
Before removing the motor unit A from the fil-
ter canister I, remove the hoses (T
release the latches G.
Do not pull on the water hoses that lead from
the motor unit A to the tank T.
12
USAGE
INJECTION-EXTRACTION WASHING
SYSTEM BY FOAM
Preparation: (see fig.①)
canister I, remove the hoses (T
the latches G.
unit A to the tank T.
- Pour detergent into the tank T
33Using specific detergents is indispensable for
foam production.
- Insert the hoses (T
- insert antifoam additive (Optional, not supplied) in
the tank I (see fig.③)
- Or insert a device defoamers (Optional, not supplied)
in the drum I (see fig.③)
- Insert the filter E and E2 and fix it by screw (see
fig.⑥) .
- Connect the unit to a minimum 6 bar air com-
pressor (not supplied) to coupling V1.
- Adjust the air pressure from 2 to 4 bar with knob
V3.
gent and the air compressor
- Attach the end of the hose U to the quick-release
connector A1 located on the motor unit A .
- Fix, at the end of the hose U, the most suitable acces-
sory , foamer lance R or foamer brush Q.
Operation:
- Plug the unit in.
- Turn on the switch B, to detergent position
fig.②).
- Press lever D for foam outflow.
and T ) and
- Distribute the foam.
1 2
- Release the lever on the tap (the detergent pump will
automatically shut down).
Before removing the motor unit A from the filter
Do not pull on the hoses that lead from the motor
and T
1
The air pressure setting depends on the deter-
If the detergent runs out, turn off the switches
B immediately to prevent damage to the pumps.
and T
) and release
1 2
.
1
) into the tank T .
2
. (see