Backlight; Other Information; Maintenance; Replacing Battery - CAMPAGNOLO ErgoBrain10 Manual De Uso

Backlight

The ErgoBrain10 has the backlight function. When
light turns on for three seconds by the push of either S/S or MODE button.
(By the first push of either button, the backlight turns on. Then push the
button again within three seconds, and the button operates normally.)
How to switch on/off backlight
In ODO function of Auto Timer screen (sub
mode), push SET button. The
Push SET button again and the
pears.
Note: When the power saving feature starts,
the backlight function automatically
turns off.

Other Information

• When the main unit is detached from the bracket, the data related to
chainrings/sprockets will disappear.
• If SET button is held down for about three seconds in the TM function of
Auto Timer screen, the unit automatically falls into sleep state.

Maintenance

Periodically check the position and condition of the speed sensor, cadence
sensor and the magnets.
When the main unit or the bracket is soiled, clean it with diluted neutral
detergent using a soft cloth, and then wipe it dry immediately.
Do not use benzene, alcohol or other organic solvent. It will damage the
surface.

Replacing Battery

Danger ! Keep all batteries out of the reach of children. In the
- 18
UK
icon appears.
icon disap-
event a battery is swallowed, contact a doctor im-
mediately.
CR2032
icon is on, the back-
When the battery icon starts
flashing, replace it with a new
one, according to the illustration.
Use the recommended battery
only. After replacing, format the
unit again according to the in-
structions in page 4.