Network Requirements; Display Symbols; Getting Started; Get The Network Ready - Lenco DIR-250 Manual Del Usuario

1 Requirements for using the DIR-250

1.1 Network Requirements

Before using the DIR-250, the following requirements are needed:
A broadband connection in combination with a wired/wireless access point, router or

similar network device.
The Wifi network router needs to support WIFI (802.11 b/g/n) wireless connection.

A smart phone, tablet or pc which is on the same network as the DIR-250


Display symbols

establishing Connection
No wireless connection
Wireless connection established
Wired connection established
No wired connection
VHF radio reception: Mono
VHF radio reception: Stereo
VHF radio function selected
AUX function selected
Speaker off
Search
Alarm on
Internet radio station saved as Fav.
FM radio station saved
2

Getting started

2.1 Get the network ready

For wireless W-LAN network connection:
●
Check if WLAN LINK/ACT light of the wired/wireless access point or router is illuminated.
Consult the user guide of that for any questions.
12