Lenco DIR-250 Manual Del Usuario página 14

if you Select Yes(WPS)(Only for WPS routers) and then press the WPS button on your router.
●
If you answer 'Yes', the display goes to scanning for Wireless Network and a list of available
wireless networks will appear.
NOTE: Only 2.4 Ghz networks are supported
1
2
The number of bars in the wireless symbol in front the network name (SSID) indicate the
signal strength of the network. The key symbol indicates that the network is password-
protected.
If the device does not find any wireless networks, a 'no wireless Networks found' appears on
the display. Change your location and if necessary and check your WLAN router. You can find
the SSID of your Access Point in the configuration of the Access Point (Router). Select your
network and confirm with OK, If your WLAN is password-protected, you will be prompted to
enter the wifi password.
Enter the password using the navigation control buttons on the device or remote control.
You can rotate the UP/DOWN knob to input the wifi password. if it is accidentally pressed
' ' to move a redundant entry, press '
With remote control
The cursor indicates the current entry space.
Press the corresponding number button repeatedly.
0 0(delete entry)
1 1(space) @ ! " # $ % & () * ' + - { \ | }< >?........
2 2 A B C a b c
3 3 D E F d e f
4 4 G H I g h i
' to correct.
14