Cleaning And Care - WMF KULT Pro Serie Instrucciones De Uso

Cleaning and care

Remove the mains plug after use. The motor unit (8) should never be placed in water, only wiped down
with a damp cloth. Never use abrasive cleaning agents. When cleaning the cutter inserts (5) and the
skewer support, be careful not to hurt yourself on the sharp blades and edges; Ideally, use the provided
washing-up brush (10), and you must always hold the cutter inserts (5) by the plastic parts. All
removable parts (stopper (1,3), collection container (9), filler tubes (2,4), cutter insert holders (6) and
cutter inserts (5)) can be placed in the dishwasher to make cleaning easier. However, we recommend
gently cleaning the cutter inserts (5) with warm running water and using a washing-up brush (10).
Regular washing in the dishwasher may blunt the blades.
Dishwasher safe
Stopper (1,3)
Collection container (9)
Filler tubes (2,4)
Cutter insert holder (6)
Cutter inserts (5)
Motor unit (8)
14
Can be rinsed Wipe with a damp
under running cloth
water
For UK use only
▪ This product is supplied with a 13 A plug conforming to BS 1363 fitted to the
mains lead. If the plug is unsuitable for your socket outlets or needs to be
replaced, please note the following. If the plug is a non-rewireable one, cut
it from the mains lead and immediately dispose of it. Never insert it into a
socket outlet as there is a very great risk of an electric shock
▪ The replacement of the plug at the mains lead has to be done according to the
following instructions:
Important: The wires in this mains lead are coloured in accordance with the
following code:
blue Neutral
brown Live
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows
⋅ the wire which is coloured blue must be connected to the terminal which
is marked with the letter N or coloured black,
⋅ the wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
Do not connect any wire to the terminal which is marked with the letter
E or by the earth symbol , or coloured green or green and yellow.
▪ If a 13 A (BS 1363) plug is used it must be fitted with a 3 A fuse conforming
to BS 1362 and be ASTA approved. If any other type of plug is used, the
appliance must be protected by a 5 A fuse either in the plug or adapter or at
the distribution board.
If in doubt - consult a qualified electrician.
▪ Never use the plug without closing the fuse cover.
The device complies with the European Directives 2014/35/EG, 2014/30/EG and
2009/125/EG.
At the end of its service life, this product may not be disposed of in the normal
household waste, but rather must be disposed of at a collection point for recy-
cling electrical and electronic devices. The materials are recyclable according to
their labelling. You make an important contribution to protecting our environ-
ment by reusing, recycling or utilising old devices in other ways. Please ask the
municipal administration where the appropriate disposal facility is located.
Subject to change.
15