Manual Operation; Preset Programs - Breville the Super Q Manual De Instrucciones

MANUAL OPERATION

Speed Control Dial
Turn the Speed Control Dial clockwise
to select one of 12 speed settings from a
slow STIR through to a very fast MILL.
To stop blending, turn the Speed Control
Dial counterclockwise back to READY.
The blender is programmed to allow manual
speeds to run for a total of 6 minutes
(68-ounce Jug) or 30 seconds (Personal
Blending Cup) before automatically stopping.
WARNING
Never blend boiling hot liquids.
Allow temperature of ingredients
to cool down to room temperature
before placing into blender jug.

PRESET PROGRAMS

PULSE | ICE CRUSH
A program of continuous pulsing
designed to chop food into an even
consistency or crush ice cubes.
SMOOTHIE
For dairy-based smoothies. A combination
of speeds and pulses designed to
combine and aerate ingredients into
a smooth and creamy texture.
GREEN SMOOTHIE
For blending whole fruits/vegetables into
a smooth beverage. A combination of high
speed profiles breaks down tough fibers into
very fine particles. Use the tamper if necessary.
12
FROZEN DESSERT
A high speed program to break down frozen
fruit/vegetables into a dessert ready to
scoop. Use the tamper for best results.
SOUP
This program is exclusively for creating
a Cold to Hot Soup – turning whole
ingredients at room temperature into a
smooth, hot soup. Primarily a high speed
program, the program will finish with a
slow stir to remove steam bubbles.
NOTE
Raw foods such as meats and seafood need to
be cooked prior to using the SOUP program.
WARNING
Do not add hot ingredients when using
the SOUP program.
CLEAN
Use to remove most of the ingredients off the
blender walls and blades. Add 4 cups of warm
soapy water to the blender jug and press the
CLEAN button. For harder to clean, sticky or
thick ingredients, add ½ teaspoon of liquid
dish detergent for extra cleaning power. For
best results, clean the blender jug this way
immediately after use.
NOTE
If the blender is running and you press
a different preset button, it will switch
to that program without stopping. If a
program is running and you press the
same program button again, it will pause
that program and timer. To resume press
the same program button again.