Aux In Mode - Lenco DIR-140 Manual Del Usuario

Bluetooth Info – information on the current state and version of the Bluetooth connection on the
radio
Connected Device – details of the currently connected Bluetooth device
Paired Device List – list of up to ten devices that have been paired with the radio
"This product has a bluetooth reception function, you can not transmit any bluetooth sound with it:
this means that you can receive a bluetooth sound signal from an external source like a smartphone."

12. Aux in mode

Aux in mode plays audio from an external source such as an MP3 player.
To play audio with Aux in mode,
1. To avoid sudden loud volume, turn the volume low on both radio and, if adjustable, the audio
source device.
2. Connect the external audio source to the Aux in 3.5mm stereo socket.
3. To enter Aux in mode, either press Mode to cycle through the listening modes until Aux in is
displayed, or select Menu > Main menu > Aux in.
4. Adjust the volume of radio (and, if necessary, the audio source device) as required.
13. Alarms and sleep
As well as clock/calendar, there are two versatile wake-up alarms with snooze facility, and a sleep
function to turn the system off after a set period. Each alarm can be set to start in a particular mode.
13.1 Sleep
To set the sleep timer, press the Sleep key on remote control repeatedly to cycle through the sleep
time options: Sleep OFF, 15 MINS, 30 MINS, 45 MINS or 60 MINS. Stop when the required time is
displayed, after a brief moment the screen returns to the screen being used before the sleep
function was selected. On the now playing screens the remaining sleep time is displayed at the
bottom of the screen. Alternatively select Menu > Main menu > Sleep and select from the sleep time
options. Once you select a sleep period, the system returns to the main menu. Press Menu to return
to the now playing screen. To cancel a sleep time, select Sleep OFF from the sleep options using
either of the above methods.
Note: A sleep time is automacatically cancelled if radio put into Standby.
13.2 Alarms
To set or change an alarm, either press Alarm on remote control or select Menu > Main menu >
Alarms.
Select the alarm number (1 or 2) then configure the following parameters:
24