Installation Preparation - GE 36 Serie Instrucciones De Instalación

Ocultar thumbs Ver también para 36 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TOOLS REQUIRED
Saber Saw
Measuring Tape
Carpenter's Square
Safety Glasses
Phillips #2
Screwdriver
Level
POWER SUPPLY LOCATIONS
Gas Supply:
• The natural gas models are designed to operate at 5"
water column pressure. For proper operation, the
pressure of the natural gas supplied to the regulator
must be between 7" and 13" water column.
• The LP models are designed to operate at 10" water
column pressure. For proper operation, the pressure
of the LP gas supplied to the regulator must be between
11" and 13" water column.
• Locate the pipe stub on the back wall or floor
(see "Product Dimensions and Clearances"). Use 5-foot
maximum length, 5/8" O.D. flexible gas supply line
(3-foot in Massachusetts).
• Install a manual shut-off valve in the gas line
(not provided), in an easily accessible location. Make sure
the homeowner knows where and how to shut off the gas
supply to the rangetop.

Installation Preparation

Drill and
Appropriate Bits
Adjustable Wrench
1/4" Driver or
Wrench
Hand Truck
7
MATERIALS PROVIDED
Hold-Down
Strap
MATERIALS REQUIRED (not provided)
Joint
Pipe Fittings
Sealant
5-foot maximum length, 5/8" O.D. CSA-approved
flexible metal gas supply
(3-foot maximum length in Massachusetts only)
NOTE: Purchase new flexible line; do not use
previously used flexible gas line.
Electric Supply:
These rangetops must be supplied with 120 volt, 60 Hz.,
and connected to a dedicated, properly grounded branch
circuit protected by a 15 amp circuit breaker or time
delay fuse.
The power cord of this appliance is equipped with a
three-prong (grounding) plug which mates with a standard
three-prong grounding wall receptacle to minimize the
possibility of shock hazard from this appliance.
If the electrical service provided does not meet the above
specifications, it is recommended that a licensed electrician
install an approved outlet.
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT
OR REMOVE THE THIRD
(GROUND) PRONG FROM
THE POWER CORD.
DO NOT USE AN EXTENSION
CORD WITH THIS APPLIANCE.
• Locate the electric supply
within the area shown or
within reach of the rangetop's four-foot power cord.
• To avoid tangling cord with items stored in the cabinet,
locate the receptacle on rear wall, inside the cabinet.
Regulator
Shut-Off
Valve

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

48 serieZgu364nrp7ssZgu364ldp2ssZgu366np6ssZgu366np2ss

Tabla de contenido