Hoshizaki DSM-12CE Manual De Instrucciones página 6

1) Attach angled end of white inlet hose (accessory)
to the G3/4 fitting on the rear of the ice dispenser
as indicated ensuring rubber sealing washer is
correctly positioned. Hand tighten sufficiently to
provide leak free joint.
2) Attach the other end of inlet hose to the water
tap, noting washer is correctly positioned before
hand tightening as above.
3) By means of a suitable spanner or wrench,
tighten the Rc1/2-G3/4 nipple (accessory) into
the R1/2 fitting on the rear of the ice dispenser
as indicated. P.T.F.E. tape and/or a suitable
sealing compound should be used to obtain a
leak free joint.
Note: Jointing compounds should be approved
and suitable for potable water use.
4) Attach grey flexible outlet hose (accessory)
to free end of Rc1/2-G3/4 nipple as indicated,
confirming fitment of rubber washer before finally
hand tightening the joint. This hose can be cut
to length as necessary to suit position of main
drain.
Fig. 3
Water Supply Inlet
G3/4
Inlet Hose
Drain Outlet R1/2
Rc1/2-G3/4 Nipple
Outlet Hose
Water Supply Tap
Inlet Hose
Fig. 4
II. OPERATING INSTRUCTIONS
WARNING
1. This ice dispenser is designed to produce
and store edible ice. To keep the ice
dispenser hygienic:
* Keep the grille clean. Clean it by using a
neutral cleaner and rinse thoroughly.
2. All parts are factory-adjusted. Improper
adjustments may result in failure.
3. If the unit is turned off, wait for at least 3
minutes before restarting the ice dispenser
to prevent damage to the compressor.
1. START UP
1) Open the water tap.
2) Plug in the ice dispenser to start the automatic
and continuous icemaking process.
3) Press the push button and check for proper ice
dispensing action after 30 - 60 minutes.
2. PREPARING THE ICE DISPENSER FOR
LONG STORAGE
1) Dispense all ice from the storage bin.
2) Close the water tap. Remove the inlet hose from
the water tap, and drain the hose.
3) Unplug the machine from power socket.
4) Replace plug in the power socket and after 30
seconds unplug it again. This will automatically
drain the water inside the machine.
III. MAINTENANCE
1. CLEANING
WARNING
1. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
m a i n t e n a n c e o p e r a t i o n s , u n p l u g t h e
ice dispenser from the electrical supply
network.
2. Ask a trained service person to clean and
sanitize the ice dispenser water system at
least twice a year and to check and clean
the condenser at least once a year.
5
ENGLISH