Ironing Tips - Oster GCSTCC3000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Type of Debris/Build-Up
Light Dirt
Hard Water Deposits
Heavy Starch or Residue
Build-up
Anti-calcium is a permanent system located inside the water reservoir to eliminate
impurities.
TO PROLONG EFFICIENCY, FOLLOW THESE STEPS ONCE A MONTH OR AFTER
EVERY 30 USES:
1. Turn off iron.
2. Add 1 teaspoon of salt to ¾ cup water and fill water reservoir with this solution.
3. Leave solution in water reservoir for 15 minutes, shake occasionally, and then empty
through the water fill hole or through the "self-clean method".
4. Fill water reservoir again with salt water solution, shake and empty after 15 minutes.
5. Fill water reservoir with fresh water to rinse and empty.
For more ironing tips and hints, please visit oster.com
Before ironing, check the garment label and follow manufacturer's instructions. If no
instructions, start with a low-heat setting and test by ironing a small area, and gradually
increase heat.
Sort garments by fabric type. Iron articles requiring a low-temperature setting and
gradually work up the temperature range.
When changing from a high-temperature setting to a lower one, allow 5 minutes for
change to allow the iron to heat up or cool down.
When steam ironing, use long, slow passes over the fabric to allow the steam to penetrate
the fabric and the heat of the soleplate to dry the moisture.
Iron linen garments inside out to prevent shine. An ironing cloth or cotton fabric can be
used to reduce shine.
Iron cotton while the fabric is still damp, or pre-moisten it with a spray bottle. Set the
temperature to a high setting and use steam for stubborn wrinkles and creases
Iron denim on the highest heat setting and use steam. Use starch for crisp, neatly creased
fabric.
Ensure zippers are closed and flap is flat. Iron over the flap, holding the garment taut.
Spray starch makes the job easier.
Cleaning Recommendation
Use a cotton cloth or terrycloth towel to wipe the
soleplate with warm soapy water.
Use a cotton cloth or terrycloth towel to wipe the
soleplate with a 50/50 vinegar/water mixture.
Use Hot Iron Cleaner or Mr. Clean
cleaning pad. Refer to the manufacturer's directions
included with these products for specific cleaner usage
instructions.
Mr. Clean
and Magic Eraser
®
trademarks owned by the Procter & Gamble company.
Anti-Calcium System

Ironing Tips

English - 8
Magic Eraser
®
®
are registered
®

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido