Publicidad
Idiomas disponibles
Idiomas disponibles
protect.
Maternity
belt
Support belt for reducing back pain
during pregnancy
Indications
• Lower back pain during pregnancy
Contraindications/side effects
Currently none known
Mode of action
The integrated stabilisation rods in the
lumbar region and the adjustable
tension of the tension straps reduce the
frontal strain that is caused by the
increasing weight of the abdomen,
relieving pressure on the abdominal
wall, the pelvis and the spine.
Properties
• Velcro fastening, allows simple
application, adjustment and removal
• Stabilisation rods in the lumbar region
prevent the material from rolling
• Reduction of lower back and back pain
through noticeable relief for back
muscles
• Anatomical form ensures perfect fit.
• Proven support function
Instructions for putting on
• Place the maternity belt around your
hips and position it so that the
stabilisation roads are located over
your spine in the middle of your lower
back. Next fasten the two ends at the
front under your abdomen (Fig. 1).
Make sure that the belt is positioned
well and does not bother you when
walking or sitting.
• To fasten the elastic tension straps,
place your hands in the loops of the
two tension straps on the outermost
side (Fig. 2). Pull these forwards until
you reach the desired level of tension.
Using the Velcro fastening, gently
press the straps to attach them to the
belt.
Care instructions
Close the Velcro before washing. Use a
wool or fine wash detergent and wash at
30°, preferably as handwash. Avoid
rubbing and spinning, rinse the material
thoroughly and lay out flat to dry. Do not
wring, spin, tumble-dry, dry on radiators
or place in direct sunlight. Do not iron.
Do not remove stains with benzene or
other chemical cleaning agents. Do not
dry-clean.
Storage instructions
Must be stored dry and at room
temperature. Must be protected from
the sun and moisture.
Statutory Defects Liability /
Contractual Guarantee
Consistent with legal guidelines
English
Publicidad
