Linear Contact Speeds Measurement - Metres, Yds, Feet Etc; Autorange Selection - Speed Modes Only; Average Speed Monitoring Mode - Av; Operation Of Maximum & Minimum Modes Speed Capture Functions - Mx, Mn - SKF TMRT 1 Instrucciones De Uso

3.4 Linear contact speeds measurement -
metres, yds, feet etc.
See section 3.1
• Fit contact adaptor as above.
• Keeping the on button pressed, now place the contact wheel on the
moving surface and read the linear rate, ensure wheel is vertical to
the moving surface.
• Releasing the on button will then hold the last reading in the display
for 1 min.
• The instrument retains selected measurement mode for further
linear measurements after switch off until programmed to a
different mode.

3.5 Autorange selection - speed modes only

• While taking a measurement using either up or down measure
button, the user can toggle between auto and non-auto mode by
pressing the programme button, in the auto mode, the A icon will
illuminate.

3.6 Average speed monitoring mode - av.

See section 3.1
• Average speed mode - this mode provides a rolling average of the
last 8 measured values.
• Press and hold the On/off button at the forward arrow position and
hold continuously
• Aim light beam onto target, ensure "on-target" sign is on at bottom
of display screen.
• Take rpm reading.
3.7 Operation of Maximum & Minimum modes
Speed Capture functions - mx, mn.
See section 3.1
• Having selected the required mode, i.e. Maximum or Minimum,
(mx,mn).
• You are now ready to Capture a reading "On Demand" but continuing
to operate normally.
• When a capture test is ready to commence, while the Measure
button is held On, press Programme button once, at this point the
instrument will switch into high speed Timebase mode,
(0,1 Seconds) and will Capture the highest or lowest reading after
pressing the Programme button.
Releasing the On button will hold the reading and cancel the Capture
mode until another Capture measurement is required, when 3.7
should be repeated.
8 SKF TMRT 1