Count Measurement Mode - Cnt; Total Linear Length Measurements - Mt, Ft, Yd; Time Interval Measurement - Int; Display Orientation - Inverting Function - All Modes - SKF TMRT 1 Instrucciones De Uso

3.8 Count measurement mode - cnt

See section 3.1
• Select the count mode (cnt).
• For counting revolution optically, point the light beam at the target
and the instrument will measure all revolutions (revs) until button is
released, the display will hold Count for 1 minute.
• By contact method, fit contact adaptor, press speed cone onto the
end of the shaft, the Instrument will count revolutionds.

3.9 Total Linear Length measurements - mt, ft, yd

See section 3.1
• Select any linear unit of measurement, press contact wheel onto
moving surface and commence Count by pressing & holding
Measure button On, Count will increment until button is released.
• The displayed value can be scanned through the equivalent values of
Metres, Feet, Yards, Count by pressing the Programming button, the
instrument automatically calculates the appropriate reading.
Note:
Measurement Units will be stored in originally programmed
parameter e.g. metres.

3.10 Time interval measurement - int

See section 3.1
• Select int mode.
• This mode allows measurement of Time between pulses from
optical system (or contactor).
• Optically the instrument will measure the time in seconds between
pulses, useful for cycle timing of reciprocating machinery.
• (Time in seconds per revolution), which equals reciprocal speed.
• Very slow speeds can be measured in this mode below 3 rpm.

3.11 Display orientation - Inverting function - All modes

• The instrument can be used through 180° rotation
(e.g. with the light beam pointing downward into a machine),
the display inverts so that normal reading can take place.
• The UP Button selects normal mode for optical and contact
measurements.
• The Down button selects the display inversion mode and the whole
display including relevant icons will reverse through 180 degrees
allowing access to difficult applications.
SKF TMRT 1 9