Display Of Operating Status Conditions; Connection Of Accessories; Switching On The Communication Unit; Switching Off The Communication Unit - Dräger FPS-COM 7000 Instrucciones De Uso

Use
3.1.2

Display of operating status conditions

The communication unit provides information on specific status
conditions using the LED and signal tones (see first fold-out page).
When the LED flashes this means:
1 Ready for operation
2 Start
data transfer to PC, where applicable
3 Installation of an update to internal processors
or
shut-down
4 Bluetooth: Pairing/establish new connection
5 Bluetooth: Reconnecting/restore known connection
6 Warning: Battery charge has decreased to only 25 %
7 Warning: Battery charge has decreased to only 10 %
8 Warning: Fault
9 Warning: Battery voltage too low, the communication unit is not
activated
3.1.3

Connection of accessories

The communication unit may only be used in potentially explosive
atmospheres with accessories that are intrinsically safe. If accessories
that have not been approved by Dräger are used, compliance must be
ensured with the parameters specified in the supplement 9031244.
NOTICE
i
i
The voice quality of the communication unit can be influenced
by the connected radio and its settings.
3.1.4

Switching on the communication unit

Press the ON/OFF button for approx. 1 second.

The LED lights up in green and an acoustic signal indicates that
the communication unit is operational.
26
3.1.5

Switching off the communication unit

Press the ON/OFF button for at least 3 seconds.

The LED flashes green and an acoustic signal indicates that the
communication unit is switched off.
3.1.6 Switching off the voice amplifier unit/switching on
HazMat mode
1. Turn on the communication unit.
2. Keep the ON/OFF button pressed for approx. 8 seconds. Ignore
the shut-off signal when doing this.
An optical and an acoustic
communication unit is in HazMat mode.
The voice amplifier unit is switched off, the radio connection is still
working.
3.1.7

Adjusting the volume

NOTICE
i i
Press and hold down the volume controller for half a second
each time. Simply touching it does not change the setting.
To increase the volume, press the volume controller repeatedly

forward until the desired level is reached.
To reduce the volume, press the volume controller repeatedly

backward until the desired level is reached.
An acoustic signal indicates that the volume has been adjusted.
Another acoustic signal indicates that no further volume level is
available.
signal indicate when the
Dräger FPS-COM 7000