Troubleshooting - Dräger FPS-COM 7000 Instrucciones De Uso

Troubleshooting

4 Troubleshooting
Fault Cause
General
Communication unit Batteries depleted
cannot be switched
Batteries not inserted
on
correct way round
ON/OFF button soiled Clean ON/OFF
No voice amplifier unit Temporary HazMat
mode selected (see
Chapter 3.1.6 on
Page 26)
Communication unit
configured for HazMat
mode
Voice amplifier unit Loudspeaker/
too unclear membrane soiled
Water in loudspeaker Allow communication
Earphone too quiet Volume set too low
Position of earphone
incorrect
Battery voltage too
low
30
Fault
No output to
earphone
Remedy
Replace batteries.
Insert batteries
according to
markings.
Communication unit
does not react
button.
anymore
Restart
communication unit
without HazMat
mode.
Change configuration
Bluetooth
with PC software.
Radio cannot be
coupled to
Clean communication
communication unit
unit.
unit to dry.
Check volume and
Bluetooth connection
adjust if necessary.
cannot be
Correct position of
reestablished
earphone.
Replace batteries.
Cause Remedy
Incorrect Check configuration
configuration (e.g.: with PC software and
earphone fitted on change it.
left, however,
communication unit is
configured for output
to right earphone)
Earphone faulty Replace earphone.
Press the ON/OFF
button for at least
15 seconds. The
communication unit
powers off.
Remove and reinsert
the batteries.
Incorrect insert used Use suitable insert.
Incorrect settings on Check Bluetooth
radio settings on radio.
Couple
communication unit
again to radio.
Communication unit Couple
not coupled to used communication unit to
radio radio.
Check Bluetooth
settings on radio.
Dräger FPS-COM 7000