Replacing The Centre Brush - BM2 BIEMMEDUE DUSTY 1100 ET Manual De Uso Y Mantenimiento

lever clamp
end of cable
Remove the cable;
•
Grease the new cable, then insert into the lever and
•
sheath;
Pass through the hole in the brush arm;
•
Thread the clamp onto the cable and block it in position
•
in such a way that when the lever is pushed forwards,
the length of the cable is such that the arm touches the
stop.
8.4.13 Replacing the side brushes
When the side brush is worn, it can be replaced following the
procedure in paragraph "installation"
side brushes.
8.4.14 Adjusting the centre brush
To work correctly, the centre brush must be in contact with the
ground for a surface area measuring 6 cm wide and the length of the
brush. To adjust the height of the brush and therefore the contact
surface:
Move the brush control downwards;
•
The centre brush is mounted on two swing arms, one per
•
side, held in place by a threaded bar fastened to the
machine chassis by one adjustment nut and one lock
nut;
Unscrew the lock nut;
•
Adjust the height of the brush using the adjustment nut;
•
Tighten the lock nut;
•
8.4.15

Replacing the centre brush

To replace the centre brush, follow this procedure:
Remove the left side guard;
•
Unhook the side brush elastic belt.
•
elastic belt
describing mounting of the
adjustment and
lock nuts
threaded bar
swing arm
Remove the screw fastening the pulley to the shaft;
•
Remove the pulley;
•
Remove the key;
•
Remove the screw on the shaft of the rear linkage;
•
Remove the nuts from the linkages and remove the rear
•
linkage;
Remove the front linkage;
•
Remove the screws and cover;
•
Remove the LH drive wheel;
•
pulley
key
shaft screw
rear linkage
linkage nuts
front linkage
cover