Know Your Car Seat - KIKKA BOO 4IN1 Instrucciones De Uso

WARNINGS:
1. The steel components and plastic components of safety seat have to be fixed by referring to manual, which ensure safety seat not be stuck by car seats and
car doors.
2. Any straps holding the restraint to the vehicle should be tight, that any straps restraining the child should be adjusted to the child S body, and that straps
should not be twisted.
3. Any lap strap is worn low down, so that the pelvis is firmly engaged, shall be stressed.
4. It can not be used when it has been subject to violent stresses in an accident.
5. It's dangerous to make any alterations or additions to the chair without the approval of the Type Approval Authority, and it's a danger of not following
closely the installation instructions provided by the child restraint manufacturer.
6. The chair should be kept away from sunlight, otherwise it may be too hot for the child's skin.
7. Please do not leave your child in their child restraint system unattended.
8.Any luggage or other objects liable to cause injuries in the event of a collision shall be properly secured.
9. a:The child restraint shall not be used without the cover.
b:The seat cover should not be replaced with any other than the one recommended by the manufacturer, because the cover constitutes an integral part of
the restraint performance.
10. The instructions can be retained on the child restraint for its life period.
11. Do not use any load bearing contact points other than those described in the instructions and marked in the child restraint.
12. The rigid items and plastic parts of a child restraint shall be so located and installed that they are not liable, during everyday use of the vehicle, to become
trapped by a movable seat or in a door of the vehicle.
13. Any luggage or other objects liable to cause injuries in the event of a collision shall be properly secured
14. Safe driving is the best way to protect children, and children's safety seats can protect children effectively but cannot completely eradicate the harms of
car accidents.
15. Please be sure to use the right Group of the children's seats with appropriate methods of application, which refer to the instructions manual of child
restraint system. Otherwise, there is potential risk to cause child injuries.
16. The child safety seat must not be positioned anywhere where it is in range of an airbag which is being deployed.otherwise.once accident happened.air-
bag can hurt your child.
17. If there is mutual interference between the adult safety-belt buckle and the main load bearing contact points on the restraint, it cannot be used. The user
shall be advised to contact the child restraint manufacturer if in doubt about this point.
18. Don't use forward facing before the child's weight exceeds 9kg.
19. Rearward facing can not be installed in the position which is equipped with airbag.
20. Keep the instruction for future use.

1. KNOW YOUR CAR SEAT

1. Headrest setting key; 2. Headrest; 3. Pillow ; 4. Guiding hook for Group II and III; 5. Cushion (used less than 13kg); 6. Harness buckle; 7. Buckle pad; 8.
Central adjuster; 9. Harness adjuster strap; 10. Seat body; 11. Guiding path for Group 0+; 12. Locking device; 13. Shoulder pads; 14. Harness guider for
Group II+III; 15. Cushion (used less than 9kg); 16. Gear indicator for setting posture;17. Seat base; 18. Button;19. Guide path for Group 0+; 20. Locking
device; 21. Group I guiding slot harness guider; 22. Group II+III harness guider 23. Group II+III guiding hole 24. Gear bar; 25. Harness shaft; 26. Harness
strap; 27. Harness yoke; 28. Harness adjustment strap; 29. Instructions slot;
2. SELECTION CRITERIA FOR BABY CAR SEAT
• This type baby car seat is applied to Group 0+/1/2/3 and the requirement for weight is form O to 36kg. It is suitable for around O to 12 year-old children. It
only can be suitable to use in the listed vehicles fitted 3 point/with retractor safety-belts, approved to EGE Regulation No.16 or GB14166.
• Different installation methods should be applied to children in defferent group. Please follow the below standards to match the right group installation.
• Do not use any load bearing contact points other than those described in the instructions and marked in the child restraint system.
• Baby car seat for Group O+ can not be installed in position which is equipped with airbag.
3. GROUP 0+ INSTALLATION
ATTENTION:
1. The installation for Group 0+ is rearward facing and is applied to children from O to 13kg.
2. This car seat for Group 0+ only has one sitting posture and it is level 4.
3. Baby car seat for Group O+ can not be installed in the position which is equipped with airbag.
4. Please place the cushion for Group O+ into the car seat when using rearward facing.
5. Important - If your child's weight is less than 9kg, you cannot make forward facing installation.
ENGLISH