Cleaning The Filter - Taurus LYSS 2300 Manual De Instrucciones

ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance by using one of the speed
selection buttons.
- Unplug the appliance from the mains.
- Clean the appliance.
ACCESSORIES:
AIR CONCENTRATOR ACCESSORY (FIG.1):
- This accessory is used to concentrate the air
flow into one specific area.
- Attach the unit to the product by pressing until
you hear a click (Fig.1).
DIFFUSER ACCESSORY (FIG.2):
*ONLY IN MODEL HD2200I- LYSS 2300 IONIC
- This accessory is used to harmonize the air
flow into one specific area.
- Attach the unit to the product by pressing until
you hear a click (Fig.2).
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- When the appliance switches itself on and
off repeatedly, for reasons other than the
thermostat control, check to ensure that there
are no obstacles that impede correct air entry
or expulsion.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.

CLEANING THE FILTER:

- The air inlet filter should be cleaned periodical-
ly for proper operation of the device.
- To do this, turn the filter counterclockwise (Fig.
3)
- Clean the filter and remove any dirt or hair.
- Put the filter back in its place and turn clock-
wise