Installation; Required Tools; Initial Conditions And Checks Prior To Installation - Erreka IZAR O MAXI VIVO-D102 Manual Del Instalador

INSTALLATION

1

REQUIRED TOOLS

Set of screwdrivers
Electrician's scissors
Tape measure
2

INITIAL CONDITIONS AND CHECKS PRIOR TO INSTALLATION

Initial installation conditions

Ensure the operator is correctly installed in the
door.
Suitability of the devices
Before starting installation:
• Check that the material to be used is in a perfect
condition and suitable for use.
• Ensure that all the devices necessary to guarantee
the safety and operation of the facility are in place.
• Check that all devices to be installed are suitable for
the facility. Pay particular attention to the use limits,
checking the "Technical Characteristics" of all
devices installed. Use only suitable devices.
Risk analysis
• Analyse all possible risks in the facility, taking into
account the essential safety requirements set out in
the Machinery Directive and in applicable standards,
and indicate the solutions chosen.
• Establish the tests to be carried out in accordance
with the risks present, and check that all envisaged
laws, standards and regulations, in particular the
requirements of Standard EN 12453:2017, which
establishes the test methods, are complied with.
40
Installation Manual
Marker pencil
Electrical drill and broaches

Use the electrical drill in line with the user
manual.

An earthed power supply of 230Vac / 50Hz
(VIVO-D102) or 125Vac / 60Hz (VIVO-D102M) is
required.
• Do not modify any part of the automatic device
unless envisaged in this manual. The manufacturer
will not be liable for any damage caused by products
which have been arbitrarily modified.
• Do not allow the devices to be submerged in water
or other liquids. In the event of ingress of water,
disconnect the power supply and contact the
Technical Service.
• Do not place the devices near heat sources or
exposed to flames. Avoid falls and crushing.

Risk analysis is one of the documents which form
part of the automation technical file which must be
filled out by a professional installer.