Programming Sequence - Erreka IZAR O MAXI VIVO-D102 Manual Del Instalador

3

PROGRAMMING SEQUENCE

General navigation through the programming parameters and menus
Display
?
ENTER
á
or
ESC
à
CL

Before entering the programming menus, it is
necessary to close the door or disconnect the device
and then reconnect.

Press the ENTER button to access the programming
menus.
The display shows "C"1 01 or "C"1 0 2.

Use the keys ^ and to select the required values,
V
and confirm by pressing ENTER.

Use ESC to go back to the previous display.

To leave the programming menu, press ESC several
times until the display goes off or shows CL.
Prior Conditions Programming (D1= "C")
1 Press ENTER to access the programming menus. The
display lights up and D1 flashes.
2 Press the buttons ^ and
C flashing. Press ENTER to confirm.
D2 flashes.
3 Press the buttons ^ and
parameter appears. Press ENTER to confirm. D3 and
D4 flash.
D1 D2 Parameter
C 1
Motor turning direction
4
Opening safety device (contact
in the pedestrian door). Prevents
the main door from starting to
open
5 Closing safety device (photocell
or strip)
D1
ENTER
á
C
ESC
à
Select the value
using ^ and
V
until D1 shows the letter
V
until the required D2
V
D3 D4
0 1
0 2
0 0
0 1
0 0
1 0
1 1
STARTING UP AND PROGRAMMING
D2
ENTER
á
1
ENTER
(confirming)
à
Select the value
using ^ and
ESC
V
(unconfirmed)
à
1 Programme the prior conditions (see "Prior
Conditions Programming (D1= "C")" on page 47).
2 Programme the radio codes, along with the door
open/close (see "Radio code programming (only
with RSD) and door open/close programming (D1=
"P")" on page 48).
3 Programme the functioning
automatic standby time (see "Main Functions
Programming (D1= "F")" on page 48).
4 Programme the advanced functions (see "Advanced
Functions Programming (D1= "A")" on page 49).
4 Press the buttons ^ and
D4 value appears (see chart). Press ENTER to
confirm.

If "motor turning direction" is selected after
pressing ENTER, the display shows
the door can be operated using the ^ and
to check turning direction. Press ESC to finish the
check.
5 Press ESC to return to the previous display.
Predetermined
Options
option
x
x Device not installed
Device installed
x Device not installed
Device without testing
Device with testing
D3 - D4
0 x
Select the value using
^ and
V
mode and the
until the required D3 and
V
. At this point
buttons
V
VIVO-D102 Control board
47