Demolition Hammer Safety Warnings; Standard Accessories; Prior To Operation - HIKOKI H 60MC Instrucciones De Manejo

DEMOLITION HAMMER SAFETY WARNINGS

1. Wear ear protectors
Exposure to noise can cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Do not touch the bit during or immediately after operation.
The bit becomes very hot during operation and could
cause serious burns.
SPECIFICATIONS
Voltage (by areas)*
Power Input
Full-load Impact Rate
Weight (without cord, side handle)
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case .............................................................................1
l type: bar type handle .........................1
(2) Side Handle
ll type: D type handle ...........................1
Either type l or type ll Side handle is attached.
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
○ Demolishing
(1) Bull Point
Overall Length: 280, 400 mm
○ Asphalt Cutting
(1) Cutter
○ Surface Roughing
(1) Bushing Tool
○ Tamping
(1) Rammer
○ Groove digging and edging
(1) Cold chisel
Overall length: 280, 400 mm
(2) Shank
(2) Shank
4. Before starting to break, chip or drill into a wall, fl oor
or ceiling, thoroughly confi rm that such items as electric
cables or conduits are not buried inside.
5. Wear a mask when turning your head upward.
6. Properly set the bit holder
7. At the start of work, confi rm screw tightening.
8. When working at a highly elevated location, pay attention
to articles and persons below.
9. Wear protective shoes to protect your feet.
(127 V, 220 V)
1250 W*
1600/min
10.2 kg
○ Scooping Work
○ Hammer Grease A
500 g (in a can)
70 g (in a tube)
30 g (in a tube)
Optional accessories are subject to change without
notice.
APPLICATIONS
Demolishing concrete, chipping off concrete, grooving, bar
cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility installation,
machinery installation, water supply and drainage work,
interior jobs, harbor facilities and other civil engineering
work.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If the
plug is connected to a receptacle while the power switch
is in the ON position, the power tool will start operating
immediately, which could cause a serious accident.
3. Extension cord
When the work area is removed from the power source,
use an extension cord of suffi cient thickness and rated
capacity. The extension cord should be kept as short as
practicable.
4. Installing Tools
CAUTION
Be sure to switch power OFF and disconnect the plug
from the receptacle to avoid serious trouble.
English
(1) Scoop
4