JVC KD-R988BTS Manual De Instrucciones página 28

AUDIO SETTINGS
Speaker output settings
[SPK/PRE OUT]
(Applicable only if [X ' OVER TYPE ] is set to [2-WAY]) ( 23)
Select the output setting for the speakers [SPK/PRE OUT], based on the
speaker connection method.
Connection via lineout terminals
For connections through an external amplifier. ( 35)
KD-R988BTS:
Setting on
[SPK/PRE OUT]
FRONT
REAR/REAR Front speakers output Rear speakers output Subwoofer output
(default)
REAR/SUB.W ( Not available )
SUB.W/SUB.W Front speakers output L (left): Subwoofer
KD-R888BT:
Setting on
[SPK/PRE OUT]
REAR/REAR Front speakers output
REAR/SUB.W (default) Front speakers output
SUB.W/SUB.W Front speakers output
24
ENGLISH
Audio signal through lineout terminal
REAR
( Not available ) ( Not available )
Subwoofer output
output
R (right): (Mute)
Audio signal through lineout terminal
FRONT REAR/SW
Rear speakers output
Subwoofer output
Subwoofer output
Connection via speaker leads
For connections without using an external amplifier. However, with this
settings you can also enjoy the subwoofer output. ( 35)
Setting on
[SPK/PRE OUT]
REAR/REAR
REAR/SUB.W
SUB.W/SUB.W
If [SUB.W/SUB.W] is selected:
SW
– [120HZ] is selected in [SUBWOOFER LPF] and [THROUGH] is not available.
– [POSITION R02] is selected in [FADER] and selectable range is [POSITION
R15] to [POSITION 00].
Audio signal through rear speaker lead
L (left)
Rear speakers output Rear speakers output
Rear speakers output Rear speakers output
Subwoofer output
R (right)
(Mute)