Environment; Pre-Start Checks; Start And Stop Procedure - Altrad BELLE BMD 300 Manual Del Operador

Safe Disposal.
Instructions for the protection of the environment.
The machine contains valuable materials. Take the discarded
apparatus and accessories to the relevant recycling facilities.
Pre start-up inspection.
The following Pre-start-up inspection must be performed before the start of each work session or after every four hours of use, which-
ever is rst. Please refer to the service section for detailed guidance. If any fault is discovered, the BMD Minidumper must not be used
until the fault is recti ed.
1. Thoroughly inspect the BMD Minidumper for signs of damage. Check components are present and secure.
2. Check uid lines, hoses ller openings, drain plugs and any other areas for signs of leakage. Fix any leaks before operating.
3. Check the engine oil level and top up as necessary.
4. Check the engine fuel level and top up as necessary.
5. Check for fuel and oil leaks.
Honda GXV 160 Petrol Engine
Starting
1. Turn the fuel shut off valve to the ON position. See Diagram 1
2. Move the throttle control to the choke position. Do not use the choke when the engine is warm. Move the throttle control slightly
Maximum RPM (Hare) position.
3. Pull the starter grip lightly until resistance is felt, then pull briskly.
NOTE:- Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to the starter.
4. If the choke was used to start the engine, move the throttle to the fast (or high) position as soon as the engine warms up enough
to run smoothly without use of the choke.
Throttle Lever
5. Position the throttle control for the desired engine speed. For best engine performance, it is recommended that the engine be
operated with the throttle in the fast (or high) position.
CAUTION
6. Using a tachometer, check the engine speed. If you can't obtain the top no load engine speed speci ed, consult your
Honda dealer.
Stopping
7. Move the throttle control to the stop position. The fuel cock will automatically turn off.
8. When the engine has stopped, turn the fuel valve to the OFF position if you do not intend to restart the engine soon. See Diagram 2.
Fuel Valve
OFF

Pre-start Checks

Start and Stop Procedure

For safety reasons, the maximum operating speed must be adjusted with a special tool. Please consult
your authorised Honda dealer for this operation.
ON
Diagram 1

Environment

Component
Handle
Hand Grips
Chassis
Engine
Gearbox
Skip
Various Parts
11
Material.
Steel
Rubber
Steel
Aluminium and Steel
Aluminium, Steel and
Phosphor Bronze
Steel
Steel and Rubber
Fuel Valve
OFF
Diagram 2
GB
GB
GB
ON