Decals - Altrad BELLE BMD 300 Manual Del Operador

A. Operating Instructions Decal
B. Unleaded Decal
C. Gear Selection Decal
D. 4-Wheel Drive Decal
F
A - Operating Instructions Decal
1. Select the Neutral Gear position.
2. Select the Choke position.
3a. Move the Fuel Valve to the 'ON' position.
3b. Start the Engine using the Recoil Start.
4. Select desired Engine Speed.
5. Select desired Gear.
6. Press down the Brake Lever and at the same time, Pull-up the Clutch
Lever to operate the machine.
7a. Release the Clutch Lever to stop the machine.
7b. Release the Brake Lever to apply the Park Brake.
8. DO NOT change gear whilst the machine is in motion.
9. To release the Skip., Pull-up the Skip Release Lever and then lift-up the back end of the machine using the handles.
10. Select the 'OFF' position to stop the machine.
B - Unleaded Decal
Only use 'SP95 Unleaded Petrol'.
C - Gear Selection Decal
-1 = Reverse Gear. Can be used on slopes with a gradient less than 20°.
0 = Neutral Position.
1 = 1st Gear. Can be used on slopes with a gradient less than 20°.
2 = 2nd Gear.
3 = 3rd Gear.
4 = 4th Gear. Should only be used on at ground with no load.
PLEASE NOTE:- The machine should not be used on a slope with a gradient of more than 20°.

Decals

E
C
A
21
B
G
D
E. Choke Lever Decal
F. Tyre Pressure Decal
G. Safety Decal
H. Lifting Point Decal
Park Brake
H