Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• Use caution when working with voltages above 25V AC RMS or
60V DC. Such voltages pose a shock hazard.
• To avoid false readings that can lead to electrical shock, replace
batteries when a low battery indicator appears.
• Do not attempt to measure resistance or continuity on a live circuit.
• Always adhere to local and national safety codes. Use personal
protective equipment to prevent shock and arc blast injury where
hazardous live conductors are exposed.
• Do not attempt to measure voltages greater than 600V in LoZ setting.
• To avoid risk of electric shock, disconnect leads from any voltage
source before removing battery door.
• To avoid risk of electric shock, do not operate meter while battery
door is removed.
Alternating Current (AC)
A
Amperage
µA
Micro Amps
°F
Degrees Fahrenheit
Audible Continuity
Diode Test
Capacitance
+
Positive
COM Common
Double Insulated Class II
Warning or Caution: To ensure safe operation and service of this meter,
follow all warnings and instructions detailed in this manual.
Risk of Electrical Shock: Improper use of this meter can lead to risk of
electrical shock. Follow all warnings and instructions detailed in this manual.
Risk of Electrical Shock: Application around and removal from
UNINSULATED HAZARDOUS LIVE conductors is permitted.
AC
AC Measurement
Negative Reading
Auto Ranging
MIN
Minimum Value Hold
Auto Power Off
Diode Test
k
kilo (value x 10
M
Mega (value x 10
μ
micro (value x 10
Ohms
A
Amps
LoZ
Low Impedance
Hz
Frequency (Hertz)
°F
Degrees (Fahrenheit)
LPF
Low-Pass Filter
T2
T2 Temperature
T1-T2 Differential Temperature
AC+DC AC Voltage + DC Voltage
WARNINGS
SYMBOLS ON METER
Hz
°C
SYMBOLS ON LCD
MAX
)
3
)
6
)
-6
INRUSH Inrush Current
T-CAL
AVG
Direct Current (DC)
V
Voltage
Frequency
Degrees Celsius
%
Duty-Cycle
Low Impedance
Resistance (Ohms)
–
Negative
Ground
DC
DC Measurement
Data Hold
Maximum Value Hold
Low Battery
Audible Continuity
High Voltage
m
mili (value x 10
n
nano (value x 10
V
Volts
F
Farads
Relative Mode
%
Duty Cycle
°C
Degrees (Celsius)
T1
T1 Temperature
Temperature Calibration
Average
)
-3
)
-9
5
Publicidad
Tabla de contenido
