Maxi-Cosi Easy Fix Instrucciones De Uso página 8

GB
C. Adjusting the length of the support leg
• IMPORTANT! Always use the support leg to ensure the safe use of the EasyFix.
10
• IMPORTANT! Make sure the support leg is fully folded out and locked at the hinge point (10).
11
• Keep the silver control button on the support leg pressed (11,1) and move the support leg downwards
until it reaches the floor of the car (11,2).
12
• IMPORTANT! Make sure the indicator at the base of the support leg is green (12).
• In some cases the EasyFix may not be fully supported by the car seat, but entirely by the support leg.
• Release the control button and "click" the support leg into the locked position.
• Check to make sure the support leg is securely locked and stays in position by trying to move it up or
down without pressing the control button.
Checklist...
To ensure the optimum safety of your child, check the following after installation:
• Both Isofix connectors are securely attached to the Isofix anchor points: the indicator on the central
button on the support leg should be green.
• The support leg is fully folded out.
• The indicator on the base of the support leg is green.
• The entire EasyFix is installed securely and firmly in the car (check by pulling on the EasyFix).
D. Removing the EasyFix
13
• Restore the support leg to its start position by pressing the control button (13,1) and sliding the support
leg upwards (13,2).
14
• Disconnect the Isofix connectors by pressing the central button on the support leg (14). The indicator on
the central button on the support leg should be red. Considerable force may sometimes be needed in
orrder to release the buckle. If this is the case, try pushing the EasyFix into the back of the vehicle seat
while pressing the release button.
15
• Remove the EasyFix from the Isofix anchor points (15).
• Remove the EasyFix from the car.
12
English