Installing And Removing The Cabriofix; Maintenance - Maxi-Cosi Easy Fix Instrucciones De Uso

• Take the seat belt out from between the base and the blue belt clamp (23,1) and fasten the belt
23
clamp (23,2).
• Remove the EasyFix from the car.

4. INSTALLING AND REMOVING THE CABRIOFIX

A. Installing the CabrioFix
• Position the CabrioFix facing backwards (with the back facing the direction of driving) on top of the
24
EasyFix (24). The carrying handle should be in the upright position.
• Click the CabrioFix with its 2 spindles onto the anchor points of the EasyFix (25).
25
• NOTE! A clear click should be audible and the indicators should now be completely on green (26).
26
• NOTE! Under no circumstances should this product be used if the indicator remains on red. Carry out
the above actions again. In case of doubt or if you have any questions, contact the manufacturer.
• Check that CabrioFix has been installed correctly by pulling on it.
To install the child in the CabrioFix or to remove him/her, see the CabrioFix user instructions. The optimum
safety of your child is only guaranteed if the CabrioFix is used correctly. It is therefore important that you
take the time to read these instructions through carefully. However, if you do not have these instructions,
contact our service point in your country or download the necessary information from our internet site:
www.maxi-cosi.com.
B. Removing the CabrioFix
• Unlock the CabrioFix by pulling the release lever upwards and at the same time forwards (27).
27 28
This releases the spindles from the anchor points and take the CabrioFix out of the EasyFix (28).

5. MAINTENANCE

• IMPORTANT! Always remove the EasyFix from the car before carrying out any of the following.
• Use lukewarm water, soap and a rag to clean the plastic parts of the EasyFix. Do not use abrasive
cleaners.
• IMPORTANT! Never use lubricants, not even for the moving parts on the EasyFix.
Instructions for use
GB
15